Heating System Repair
in the Capital Region, NY

It depends on the system. For a furnace, the usual causes are a thermostat or power problem, a clogged filter that trips the safety limit, a dirty flame sensor or a failed ignitor (or a pilot that went out), a blocked vent, or a failed blower or control board. For a boiler, look at low system pressure or trapped air, a failed circulator, a stuck zone valve, or a burner that will not fire. Start with the checks above, then see furnace repair or boiler repair for your system.

Check the thermostat setting and batteries, the breaker and the switch at the unit, the filter on a furnace and the pressure gauge on a boiler. If the checks do not help, call us and we will confirm the next opening; we prioritize same-day no-heat calls Monday through Friday, 7:30am to 6pm. Meanwhile, close off unused rooms and add layers. A gas oven or a grill is never a heat source, and gas odor or a CO alarm means going outside and phoning 911 or the gas utility before anything else.

The price follows the fault: a thermostat, ignitor or flame sensor is one kind of job, a circulator, control board or heat exchanger another. We diagnose first, then quote a single flat figure that you approve before anything starts; there is no hourly rate, and estimates are free. Where a repair makes little sense we say so. Replacement pricing is covered in our heating replacement cost guide.

Yes, same-day no-heat calls get priority Monday through Friday, 7:30am to 6pm, throughout the Capital Region. Phone (518) 482-4205 or book online and the dispatcher confirms the next opening.

A single failed part on a system that has otherwise run well is usually a repair. Repeated breakdowns, a cracked heat exchanger or boiler section, rising fuel use, or a system well past 15 years old and failing every winter point toward replacement. We show you the diagnosis and the flat repair price, and an honest read of whether replacing makes more sense. See signs your furnace or boiler needs replacing.

Contractors often quote a shortcut: take the age of the system in years, multiply it by the repair estimate, and if the product is more than $5,000, replace instead of repairing. It is an industry rule of thumb, not an ESP price or policy, and it is only a starting point. It cannot tell a one-off failed part from a pattern, and it ignores fuel and efficiency. A cracked heat exchanger or boiler section usually settles the question regardless. We skip the formula and give you the diagnosis, a single flat repair price and a candid opinion; you make the call. See heating system replacement.

Check what you can verify. Get one price in plain terms before any work starts (ours is a single flat price after diagnosis, never hourly, and you approve it first), ask what failed and ask to see it, and confirm the license and insurance. Be wary of a large quote over the phone or pressure to decide on the spot. If a repair is not worth making, we tell you, and the choice stays yours. Our license is City of Albany #PLBG21-147, we are insured in New York, and the company has been family-owned since 2006.

It depends on the fault. A thermostat, ignitor or flame sensor problem is often finished in the same visit, while a control board or blower motor may have to be ordered and means a second trip. We spell out which one applies, and the flat price, before you approve anything.

Vents blowing air mean a furnace. Radiators or baseboard with pipes mean a boiler. An outdoor unit that heats and cools means a heat pump. Each has its own repair page: furnace repair, boiler repair and heat pump repair.

Either can, so check what the company actually repairs. A heating system is the furnace, boiler or heat pump that makes and distributes heat; HVAC also covers ventilation and air conditioning. Our crew repairs heating systems as well as plumbing, so one call covers a leaking boiler fitting, a failed ignitor or a cold radiator.

Yes. Furnaces and boilers burning gas, oil or propane are all part of the work, whether the house is on a gas main or fed from a tank.

Common red flags include no heat or weak airflow, short cycling (the system rapidly turning on and off), banging or rattling noises, a yellow or flickering burner flame, and uneven heat that can’t keep up on the coldest Capital Region nights. If you ever smell gas or your carbon monoxide detector sounds, leave the house first and then call us right away.

Yes. Every repair is backed by our workmanship guarantee, and any new parts we install carry the manufacturer’s warranty. Before we leave, we verify your system is heating safely and running the way it should, so you’re not left second-guessing it on a cold night. See our guarantee.